Firmware Updates for microOBD 200

Here you will find short summaries of changes between the different firmware revisions. Developers should read the detailed changelog found inside the respective update archive. To install an update, download and extract the archive, then run StnFirmwareUpdater.exe.

Latest Version 4.2.1

Release Date: January 30, 2017
Level of Importance: Recommended

Download

This major release fixed several bugs including:

• CAN message loss or corruption due to CAN bus errors
• ATPB could cause auto-filtering not to be set up correctly
• Undefined behavior if reset during startup
• ATMA command cleared CAN H/W filter on exit
• ATMP commands cleared all current filters on OUT OF MEMORY error
• ATBI/STPO did not activate pending USER1 protocol configuration changes
• When ATMA on startup is enabled, device may fail to exit boot mode or enter pairing mode
• Automatic generation of 11-bit flow control ID pairs for segmented message transmission
• UART transmission lock ups
• ISO 9141 keep-alive messages
• STDIX would not display the new BT device name until 2 PORs from issuing STBTDND command

The major relase added many new features including:

• Turn LEDs off/on
• Extra data parameter for the STPX command
• Set CAN addressing modes
• Set and read CAN timing registers
• Support for 7F xx 78 response pending messages
• Support for new Bluetooth modem firmware
• Report factory calibration status
• Fail-safe clock monitor
• Complete ISO 15765 multi-frame message support
• CAN Rx multi-frame message assembly
• CAN Tx message segmentation
• Arbitrary OBD message transmission
• Set Bluetooth device name
• Set minimum time between the last OBD response and the next request
• GPIO control for most digital I/O pins
• Other stability and performance improvements

See microobd-changelog.txt inside the archive for detailed descriptions of the changes.

Version 3.2.0

Release Date: September 19, 2012
Level of Importance: Recommended

Download

This major release fixes a number of serious bugs and introduces many new features.

See microobd-changelog.txt inside the archive for more details.

Latest Version 3.2.0

Release Date: September 19, 2012
Level of Importance: Recommended

Download

This major release fixes a number of serious bugs and introduces many new features.

See microobd-changelog.txt inside the archive for more details.

Version 3.1.0

Release Date: May 16, 2012
Level of Importance: Recommended

Download

This major release fixed three serious bugs:

• The device would sometimes lock up while monitoring a busy CAN bus.
• Due to a race condition, heavy UART Tx traffic sometimes would generate FATAL ERROR 0x0101 [5, ...]

The following major new features were implemented:

• New AT and ST commands, including:
  • Protocol open/close
  • Enable automatic filtering mode
  • Set automatic check byte calculation/checking
  • Set CAN monitoring mode
  • J1939 header formatting, response timeout multiplier
• Ability to turn off J1850 CRC calculation and checking
• Removed length limitation for certain types of messages
• Increased CAN buffer size
• Increased UART buffer size
• Other stability and performance improvements

See microobd-changelog.txt inside the archive for detailed descriptions of the changes.

Version 2.1.3

This release fixes a few minor bugs and introduces the following new features:

• Voltage-based PowerSave triggers
• Command to change SLEEP input polarity
• Higher precision voltage measurement

See stn1110-changelog.txt inside the archive for more details.

Version 2.0.4

Fixed a bug, where under certain circumstances J1850 Bus+ could go active when not actively transmitting.

Version 2.0.3

Bugfix release (see microobd-changelog.txt inside the archive for details).

Previous Releases